Instruction Manual

• Remove the protective plastic lm from the panels. If the appliance is exposed to the

sun or to heat, remove the lm after the appliance cools.

• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the

fan blade (if applicable) turns freely.

• Check that the compressor is snug on all mounting pads.

• Flaker models can be installed on an ice storage bin only. Cubelet models can be

installed on either a dispenser unit or an ice storage bin. The ice storage bins listed

below are recommended.

Model Number Bin Width Recommended Hoshizaki Ice Storage Bin

FD-1001M_J-C 22" or Wider BD-300 Series

F-1501M_H(-C)

F-2001M_H(3)(-C)

30" or Wider B-500 Series

For further options, contact your local Hoshizaki distributor.

• NOTICE! Remote models must be connected to an appropriate remote condenser

unit. The remote condenser units listed below are recommended. Connection to a

different remote condenser unit will void the warranty unless Hoshizaki approves

a different remote condenser unit for your specic application. For further

details, contact your local Hoshizaki distributor.

Model Number Recommended Hoshizaki Remote Condenser Unit

FD-1001MRJ-C URC-5F

F-1501MRH(-C) URC-14F

F-2001MRH(3)(-C) URC-22F

• On low-side models, an R-404A parallel rack system is needed. See "II.H. Connection

to an R-404A Parallel Rack System" for refrigeration circuit details.

C. How to Remove Panels

See Fig. 1

• Front Panel: Remove the screw. Lift up and towards you.

• Top Panel: Lift up at front slightly, push rearward and lift off.

• Side Panels: Remove the screw. Slide forward slightly and lift off.

Fig. 1

Model Shown: F-1501MRH-C

Top Panel

Side Panel

Front Panel