FREEZER Instruction Manual EUR27A EUR48A EUF27A EUF48A Issued: 07-26-2019 Revised: 03-26-2020
WARNING Only qualified service technicians should install and service the appliance. To obtain the name and phone number of your local Certified Service Representative, visit www.economyseries.com. No installation or service should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/manager should not proceed to operate the appliance until the installer has instructed them on its proper operation.
TABLE OF CONTENTS Important Safety Information ...................................................... 5 Know your Equipment ................................................................. 9 Check for Shipping Damage ......................................................... 10 Handling the Cabinet ................................................................... 11 Location ....................................................................................... 11 Remove the Crate and Skid ...............
EUR27A, EUF27A EUR48A, EUF48A 4
Important Safety Information Important Safety Information Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury, damage to the appliance, or damage to property. Indicates a hazardous situation that, if not avoided, will result in death or serious injury. Indicates a hazardous situation that, if not avoided, could result WARNING in death or serious injury.
WARNING This appliance should be destined only to the use for which it has been expressly conceived. Any other use should be considered improper and therefore dangerous. The manufacturer cannot be held responsible for injury or damage resulting from improper, incorrect, and unreasonable use. Failure to install, operate, and maintain the appliance in accordance with this manual will adversely affect safety, performance, component life, and warranty coverage.
WARNING, continued • • • • • • • • • • • • • • • • • • This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be properly supervised around this appliance. Do not climb, stand, or hang on the appliance or door or allow children or animals to do so.
WARNING, continued • • • Do not store gasoline or other flammable liquids or gases, near this or other electrical equipment. Keep your fingers away from grills; the spaces between doors and cabinet are small, so be careful when closing doors when children are around. Unplug the cooler before cleaning or performing any repair. NOTICE • • • • Protect the floor when moving the appliance to prevent damage to the floor.
Know your Equipment POWER CORD DOOR BACK GRILL CONTROL MODULE SHELF CLIP SHELF CONDENSER BOLT HEAD CASTER 9
Check for Shipping Damage Prior to leaving the factory, each cabinet is throughly inspected and performance tested to assure proper operating temperatures. Check the crate thoroughly for signs of shipping damage. If external damage exists, internal damage is also probable. Uncrating should be done while the carrier´s representative is present. Otherwise, the equipment should be uncrated as soon as possible, preferably within five (5) days.
Handling the Cabinet 1. Always move the unit in an upright position. Do not set it on its side or upside down as you may damage the cabinet and spill the compressor oil. 2. If lifting the unit, hold it from its base. It is recommended to use a dolly. 3. Do not let the unit fall abruptly. Location WARNING • 1. 2. 3. 4. 5. This appliance is not intended for outdoor use.
Remove the Crate and Skid 1. Remove the external packaging (corrugated board and plastic wrapping). Check for concealed damage. If any damage is identified, immediately forward a complaint to the transportation company. 2. Move the cooler to its final location, before removing the skid. 3. Using a screwdriver remove the screws that attaches the skid to the appliance. Screw Level the Cabinet To install casters: Casters are supplied as optional equipment.
Electrical Installation Electrical Connection WARNING • • • • • • • Electrical connection must meet national, state, and local electrical code requirements. Failure to meet these code requirements could result in death, electric shock, serious injury, fire, or severe damage to equipment. This appliance requires an independent power supply of proper capacity. See the nameplate for electrical specifications.
Installation the Shelves Shelves and shelf clips (4 clips per shelf) are packed inside the cabinet prior to shipment. After selecting the appropriate spacing inside the cabinet, install shelf clips by inserting top of clip inside the pilaster and then press the lower section of the clip while pushing inwards until it snaps into place. Repeat until all clips are in desired location. Place shelf on clips checking that all four corners of shelves are leveled and supported by the four shelf clips.
Controls and Adjustments To EUR27A, EUR48A: NOTES: - THE FACTORY DEFAULT TEMPERATURE SET POINT IS 32°F. - THE SET POINT RANGE IS FROM 32°F TO 40°F. To EUF27A, EUF48A: NOTES: • THE FACTORY DEFAULT TEMPERATURE SET POINT FOR EUF27A IS -11°F AND FOR EUF48A IS -8°F. • THE SET POINT RANGE FOR EUF27A IS FROM -1°F TO -11°F AND FOR EUF48A IS FROM 2°F TO -8°F. DEFROST CYCLES The electronic controller is programmed to perform evaporator defrost cycles every six hours with a duration of 25 minutes.
TEMPERATURE DIAL “OFF” POSITION cycling compressor compressor cycling The control knob can be set to the ‘Off’ position by turning it fully counterclockwise. This setting turns off the compressor and the fans regardless of temperature, allowing manual defrost, cleaning etc. ATTENTION This controller has a feature to protect the cooler against an electrical spike/surge. After an interruption of the power supply, the controller will delay the start of the compressor for approximately 3 minutes.
Cleaning and Preventive Maintenance Your unit requires very little maintenance. However, periodic cleaning can help maintain efficiency and prolong product life. Remember to disconnect the power source before cleaning. Remove all products and place them in another cooler. 1. Clean once a month the condenser with a grease remover. The condenser is located in the lower part of your unit, behind the front grill. Condenser 2.
Disposal DANGER FLAMMABLE • • • The appliance contains refrigerant and must be disposed of in accordance with applicable national, state, and local codes and regulations. Refrigerant must be recovered by properly certified service personnel. The insulation foaming agent used for the unit body contains flammable gas cyclopentane. With this in mind, dispose of the product properly. Remove the door to reduce the risk of children getting trapped.
SERIES 618 Hwy. 74 South, Peachtree City, GA 30269 USA MAN-343-R (P) (800) 227-3172 www.economyseries.
