Hoshizaki Hoshizaki America, Inc. Ice and Water Dispenser Model DM-200B “A Superior Degree of Reliability” INSTRUCTION MANUAL www.hoshizaki.
IMPORTANT Only qualified service technicians should attempt to install, service or maintain this product. No installation, service or maintenance should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/ manager should not proceed to operate this product until the installer has instructed them on its proper operation. HOSHIZAKI provides this manual primarily to assist qualified service technicians in the installation, maintenance and service of this product.
• Please review this manual. It should be read carefully before this product is installed and operated. Only qualified service technicians should install, service and maintain this product. This manual should be made available to the technician prior to installation, maintenance or service. • Keep this manual with this product for later reference. CONTENTS I. Specifications....................................................................................................................... 4 A.
I. Specifications A. Nameplate Rating 1. DM-200B HOSHIZAKI ICE DISPENSER MODEL NUMBER SERIAL NUMBER AC SUPPLY VOLTAGE AMPERES DM-200B 115/60/1 1.4 AMPS Hoshizaki America, Inc. Peachtree City, GA www.hoshizaki.com LISTED ACCESSORY OF ICE MAKER 946Z See the nameplate for electrical specifications. This nameplate is located on the upper right hand side of the rear panel.
B. Dimensions/Connections 1.
II. Installation and Operating Instructions A. Checks Before Installation IMPORTANT 1. Remove the shipping carton and all tape and packing material to prevent possible damage to the unit. 2. Ensure all components, fasteners and thumbscrews are securely in place. • Remove the package containing the accessories. • Remove the protective plastic film from the panels. If the dispenser is exposed to the sun or to heat, remove the film after the dispenser cools.
C. Setup IMPORTANT It is extremely important that the dispenser be leveled in both the left-to-right and front-to-rear directions. If it is not level, a reduced rate of ice flow may result. 1) Unpack the dispenser, and remove the shipping carton and all tape and packing material before operating the unit. Attach the four (4) (optional) adjustable legs to the bottom of the dispenser. The legs are adjustable from a minimum of 4 inches (102 mm) to a maximum of 5 inches (127 mm).
E. Water Supply and Drain Connections See Fig. 1 • Water supply inlet is 1/2" female pipe thread (FPT). • A water supply line shut-off valve and drain valve should be installed. A minimum of 1/4" OD copper tubing is recommended for the water supply line. • Water supply pressure should be a minimum of 10 PSIG (0.7 bar) and a maximum of 113 PSIG (7.5 bar). If the pressure exceeds 113 PSIG (7.5 bar), the use of a pressure reducing valve is required. • Drain outlet is 3/4" FPT.
F.
III. Cleaning and Maintenance Instructions IMPORTANT Ensure all components, fasteners and thumbscrews are securely in place after any maintenance or cleaning is done to the equipment. A. Cleaning WARNING 1. Hoshizaki recommends cleaning this unit at least once a year. More frequent cleaning, however, may be required in some existing water conditions. 2. To promote safety, always unplug the unit from the electrical outlet before any cleaning and maintenance procedures are started. 3.
Cover Bin Front Panel Snap Pin Agitator Screw Shutter Assembly Spout Apron Panel Thumbscrew Fig.
B. Maintenance – Exterior Panels To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a damp cloth containing a neutral cleaner to wipe off oil or dirt build up. C. Preparing the Dispenser for Long Storage CAUTION When shutting off the dispenser for an extended time, drain out all water from the water line and remove the ice from the dispensing bin. The bin should be cleaned and dried.
HOSHIZAKI AMERICA, INC. 618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.
