Instruction Manual

17
1. Icemaker
• Icemaker water supply inlet is 1/2" female pipe thread (FPT). A minimum of 1/4"
nominal ID copper water tubing or equivalent is required for the icemaker water supply
line.
• An icemaker water supply line shut-off valve and drain valve should be installed.
• Ice storage bin and drip tray drain outlets are 3/4" FPT. A minimum of 3/4" nominal ID
hard pipe or equivalent is required for the ice storage bin and drip tray drain lines.
Ice Storage Bin
Drain Outlet
3/4" FPT
Drip Tray
Drain Outlet
3/4" FPT
Fig. 4
Icemaker
Stand
Icemaker Water Supply Line
Shut-Off Valve
Icemaker Water
Supply Inlet
1/2" FPT
Icemaker Water Supply
Line Drain Valve
Vent
Tube
Minimum 1/4" Nominal ID
Copper Water Tubing or Equivalent
Minimum 3/4" Nominal ID
Hard Pipe or Equivalent
Separate piping to approved
drain. Leave a 2-inch (5-cm)
vertical air gap between the
end of each pipe and the
drain.
2-inch (5-cm)
air gap
Floor
Drain
Model Shown: DCM-752BAH