Service Manual
Table Of Contents
- Important Safety Information
- I. Construction and Water/Refrigeration Circuit Diagrams
- II. Sequence of Operation and Service Diagnosis
- III. Controls and Adjustments
- A. Control Board Layout
- B. LED Lights and Audible Alarm Safeties
- C. Controls and Adjustments
- 1. Default Dip Switch Settings
- 2. Infrared Sensor Shutdown Delay (S1 dip switch 1, 2, 3)
- 3. Drain Frequency Control (S1 dip switch 4)
- 4. Continuous Dispensing Timer (S1 dip switch 5 & 6)
- 5. Bin Control Selector (S1 dip switch 7)
- 6. Bin Control Shutdown Delay, Agitation, and Ice Purge Timer (S1 dip switch 8)
- 7. Bin Control Shutdown Delay (S1 dip switch 9)
- 8. Factory Use (S1 Dip Switch 10)
- D. Switches
- IV. Refrigeration Circuit and Component Service Information
- V. Maintenance
- VI. Preparing the Appliance for Periods of Non-Use
- VII. Disposal
- VIII. Technical Information
47
Evaporator Assembly
Fig. 14
Spout B
Spout A
Power Switch
Evaporator Assembly
Safety Switch
CONTROL
DISPENSE MODE
4A1038-014
ICE
OFF
DRAIN
PORTION
CONTINUOUS
Extruding Head and
Upper Bearing
Evaporator
Allen Head Cap Screw with Washer
Allen Head Cap Screw (with seal)
Not reusable
Housing and Lower Bearing
Gear Motor
Spline Coupling
O-Ring
Mechanical Seal
Auger
Hex Head Bolt with Washer
Washer
Evaporator Heater
DCM-500B_H(-OS)
DCM-751B_H(-OS)
DCM-752BAH(-OS)
Cutter
Storage Bin
Cover
Control Switch
Dispense
Mode Switch
Left Side Panel
Apron Panel
Right Side Panel