Service Manual

32
No Ice Production - Possible Cause
Rell
1. Water Supply a) Off.
2. Control Board a) No power to oat switch (5VDC) or not reading oat switch
condition.
b) No power to inlet water valve (24VAC).
3. Float Switch a) Float does not move freely.
b) Defective.
4. Inlet Water Valve a) Clogged or defective.
Shutdown
1. Bin Control a) Actuator paddle sticking open.
b) Proximity switch defective.
2. Control Board
See "II.C. Control Board Check"
a) S1 dip switch settings not set correctly.
b) Defective.
2. Ice/Water Dispensing
Ice Dispense-Push Button
1. Power Supply a) Off, blown fuse, or tripped breaker.
2. Control Board a) Ice dispense switch circuit open or no power (5VDC) from control
board.
b) No power (115VAC) to ice dispense solenoid, ice dispense motor, or
agitating motor.
3. Ice Dispense Switch a) Defective.
4. Dispense Mode Switch a) Defective.
5. Ice Dispense Motor a) Motor windings.
b) Mechanical failure.
6. Ice Dispense Solenoid a) Defective or loose connection.
7. Shutter Assembly a) Defective.
8. Agitating Motor a) Motor windings.
b) Mechanical failure.
Ice Dispense-Opti-Serve
1. Power Supply a) Off, blown fuse, or tripped breaker.
2. Control Board a) No power to dispense mode switch.
b) Dispense mode switch circuit open.
c) No power to ice dispense solenoid, ice dispense motor, or agitating
motor.
3. Infrared Sensor a) Defective.
4. Dispense Mode Switch a) Defective (open).
5. Ice Dispense Motor a) Motor windings.
b) Mechanical failure.
6. Ice Dispense Solenoid a) Defective or loose connection.
7. Shutter Assembly a) Defective.
8. Agitating Motor a) Motor windings.
b) Mechanical failure.