Service Manual
Table Of Contents
- I. Specifications
- II. General Information
- III. Technical Information
- IV. Service Diagnosis
- V. Removal and Replacement of Components
- A. Service for Refrigerant Lines
- B. Removal and Replacement of Compressor
- C. Removal and Replacement of Expansion Valve
- D. Removal and Replacement of Evaporator Assembly Components
- E. Removal and Replacement of Self-Contained Air-Cooled Condenser
- F. Removal and Replacement of Water-Cooled Condenser
- G. Removal and Replacement of Water Regulating Valve ‑ Water‑Cooled Model Only
- H. Adjustment of Water Regulating Valve - Water-Cooled Model Only
- I. Removal and Replacement of Fan Motor
- J. Removal and Replacement of Inlet or Dispensing Water Valve
- K. Removal and Replacement of Drain Valve
- L. Removal and Replacement of Dispensing System
- VI. Cleaning and Maintenance
50
Fig. 1
Extruding Head and
Upper Bearing
Evaporator
Allen Head Cap Screw
with Washer
Allen Head Cap Screw
Housing and
Lower Bearing
Gear Motor
Barrier
Spline Coupling
O-Ring
Mechanical Seal
Auger
Cutter
Auger Pin
Hex Head Bolt
with Washer
D. Removal and Replacement of Evaporator Assembly Components
CAUTION
Make sure the extruding head heater is installed and connected after service.
Extruding Head
Heater
Washer
Spout B
Spout A
Power Switch
Control Switch
Dispense Mode Switch
Evaporator Assembly
Evaporator
Bracket