Service Manual

54
C. Preparing the Icemaker for Periods of Non-Use
NOTICE
When storing the icemaker for an extended time or in sub-freezing temperatures,
follow the instructions below to prevent damage.
When the icemaker is not used for two or three days under normal conditions, it
is sufficient to only move the control switch to the "OFF" position. When storing
the icemaker for extended time or in sub-freezing temperatures, follow the
instructions below.
1) Close the icemaker water supply line shut-off valve and open the icemaker water supply
line drain valve.
2) Move the control switch to the "DRAIN" position. Allow the water system to drain for 5
minutes.
3) Move the dispense mode switch to the "CONTINUOUS" position, then dispense all of
the ice from the storage bin.
Note: Ice dispenses continuously for a maximum of 60 seconds per activation.
4) Attach a compressed air or carbon dioxide supply to the icemaker water supply line
drain valve.
5) While engaging the water dispense switch, blow out the water dispense valve using the
compressed air or carbon dioxide supply. After blowing out the water dispense valve,
leavethecompressedairorcarbondioxidesupplyowing.Movethecontrolswitchto
the"ICE"positiontoopentheinletwatervalveandbrieyblowouttheinletwatervalve.
After blowing out the inlet water valve, move the control switch to the "OFF" position.
6) Close the icemaker water supply line drain valve.
7) Turn off the power supply, then remove the front panel and move the power switch to the
"OFF" position.
8) Remove the storage bin cover. Clean the storage bin liner and the storage bin cover
using a neutral cleaner. Rinse thoroughly after cleaning. Replace the storage bin cover
and the front panel in their correct positions.