Service Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- II. General Information
- III. Technical Information
- IV. Service Diagnosis
- V. Removal and Replacement of Components
- A. Service for Refrigerant Lines
- B. Important Notes for Component Replacement
- 1. Upper Bearing Wear Check
- 2. Removal and Replacement of Extruding Head
- 3. Removal and Replacement of Auger
- 4. Removal and Replacement of Evaporator
- 5. Removal and Replacement of Mechanical Seal and Lower Housing
- 6. Removal and Replacement of Gear Motor
- 7. Dispense Auger and Agitator
- 8. Dispense or Agitating Motor
- VI. Cleaning and Maintenance
- VII. Disposal
41
Fig. 2
Extruding Head and
Upper Bearing
Evaporator
Allen Head Cap Screw with
Washer
Allen Head Cap Screw
Housing and
Lower Bearing
Gear Motor
Spline Coupling
O-Ring
Mechanical Seal
Auger
Cutter
Hex Head Bolt
with Washer
Washer
Spout B
Spout A
Power Switch
Control Switch
Dispense Mode Switch
Evaporator Assembly
Evaporator Assembly
Ring