Spec Sheet

The exterior cabinet front, sides, and top are constructed of high quality stainless steel. The exterior back and bottom are constructed of coated steel. The cabinet interior
walls and ceiling are stainless steel. The floor is constructed of heavy gauge stainless steel with coved corner construction. Heavy duty ABS thermal breaks are used to
reduce heat transfer in the frames. Cabinet walls and drawers are insulated with 2” of environmentally friendly CFC free, foamed in place polyurethane. 4” heavy duty
platform casters (all with brakes) are standard and installed at the factory.
Cabinet Construction
Drawer fronts are constructed of high grade stainless steel with stainless steel interior and are insulated with CFC free, foamed in place polyurethane. Each drawer
accommodates (1) 12” X 20” X 6” deep pans and (2) 1/2 size long pan (pans by others). (Drawers will also accept 1/2, 1/3
rd
and 1/6
th
size pans with optional adapter bars).
Drawer module frames are formed of heavy duty stainless steel all welded construction and securely fastened in the cabinet. The drawer slides are constructed of heavy
duty stainless steel with durable acetal rollers with stainless steel ball bearings to prevent metal to metal contact. The drawer slides have been life tested (fully loaded) three
hundred thousand cycles without showing significant wear. The flush mount handles are constructed of extruded aluminum. Snap-in magnetic drawer gaskets are durable
and easily removed for cleaning.
Solid state digital controller with temperature alarms maintains optimum cabinet temperature. A LED display shows the cabinet temperature and is adjustable to Fahrenheit
or Celsius. The CR49A has a front breathing refrigeration system. The high efficiency refrigeration system is standard with an E-coated evaporator for extended life.
Condensate removal is accomplished with an energy efficient hot gas condensate evaporator system. A capillary tube controls the flow of environmentally friendly R290
refrigerant through the evaporator. Refrigeration system utilizes an automatic, time-initiated, heated defrost to eliminate any ice on the evaporator coil. 115 volt units are
equipped with a ten foot cord and plug (20.0 amps or less).
Drawer Construction
Refrigeration System
618 Hwy, 74 S., Peachtree City, GA 30269 | TEL [phone] | FAX [phone] | www.hoshizakiamerica.com
© HOSHIZAKI AMERICA, INC.
PLAN VIEW
SIDE VIEW
FRONT VIEW
• Top: A minimum of 4” (11cm) clearance is required
between the bottom of the cooking equipment heating
element and the appliance top
• Sides: 1” (25mm) clearance
• Rear: The factory installed rear bumpers must be in
place to ensure proper rear clearance.
CLEARANCES
16 gauge stainless steel
top with built in heat shield
and 1” drip edge
CR49A
12/17/18
Item # 13488
CR49A
49” Low-Profile Refrigerated Chef Base
49”
4”
26”
1”
27”
20.25”
1”
32.25”
54.75”
49”
33.25”
55.75”