Service Manual
Table Of Contents
- Important Safety Information
- I. Construction and Refrigeration Circuit Diagram
- II. Sequence of Operation and Service Diagnosis
- III. Controls and Adjustments
- IV. Refrigeration Circuit and Component Service Information
- V. Maintenance
- VI. Preparing the Appliance for Periods of Non-Use
- VII. Disposal
- VIII. Technical Information
7
NOTICE
• Protect the oor when moving the appliance to prevent damage to the oor.
• Keep ventilation openings, in the appliance enclosure or in the built-in structure,
clear of obstruction. The factory-installed rear bumpers must be in place to ensure
proper rear clearance. Blockage of airow could negatively affect performance and
damage the appliance.
• To prevent deformation or cracks, do not spray insecticide onto the plastic parts or
let them come into contact with oil.
• To avoid damage to the gasket, use only the door/drawer handle when opening and
closing.
• Do not leave the doors/drawers open.
• To avoid damage to the top seal, do not lift the appliance by the top section or
remove the top section.
Additional Notice for CPT Models
• Do not allow the appliance to bear any outside weight.
• Do not place anything on top of the rail cover and do not lift the appliance by the rail
cover. The rail cover is not designed to bear any outside weight.
• Do not place anything on the air duct panels beneath the pans in the rail. The air
duct panels are not load-bearing.