Instruction Manual
Table Of Contents
- I. Specifications
- A. Dimensions
- 1. B-1150SS
- 2. B-1300SS
- 3. B-1500SS
- 4. B-1650SS
- II. Installation Instructions
- A. Checks Before Installation
- B. Location
- C. Setup
- 1. Unpacking the Ice Bin and Attaching the Snout Assembly
- 2. Installing the Icemaker
- D. Drain Connections
- E. Final Check List
- III. Operating Instructions
- A. Baffle
- 1. Removal
- 2. Installation
- B. Sliding Doors
- 1. Removal
- 2. Installation
- C. Probe (Optional Accessory)
- IV. Cleaning and Maintenance Instructions
- A. Cleaning Instructions
- 1. Cleaning Procedure
- 2. Sanitizing Procedure - Following Cleaning Procedure
- B. Maintenance
14
C. Probe (Optional Accessory)
The probe is used to break apart ice when it has bridged inside the bin and will not flow into
the snout. To break apart ice, follow the steps below.
1) Open the bin door.
2) Insert the probe through the hole in the snout (just above the baffle).
3) Carefully move the probe back and forth until ice falls into the snout.
Fig. 4