User Manual

CH.6 SUP0740-07
11/30/2009 Page 50 of 98 # 958
Figure 6.18 - Creating Consumed Exchange 1 - Node 2
5. Click on the Add Range button, in the EGD Configuration dialog, to define a Data Block for
Consumed Exchange 1. Then fill in the parameters, as shown in Figure 6.19 below, and click
OK.
In this example, Node 2 will use Exchange 1, to receive 10 data words into %R200 through
%R209.
Figure 6.19 – Consumed Exchange 1 Data Block Definition – Node 2
At this point, the Consumed Exchanges tab in the EGD Configuration dialog should be as
shown in Figure 6.20.