User Manual

SUP0740-07 CH.6
11/30/2009 Page 45 of 98 # 958
Figure 6.11– Creating Consumed Exchange 2 - Node 1
5. Click on the Add Range button, in the EGD Configuration dialog, to define a Data Block for
Consumed Exchange 2. Then fill in the parameters, as shown in Figure 6.12 below, and click
OK.
In this example, Node 1 will use Exchange 2, to receive 5 data words into %R200 through
%R204.
Figure 6.12– Consumed Exchange 2 Data Block Definition – Node 1
At this point, the Consumed Exchanges tab in the EGD Configuration dialog should be as
shown in Figure 6.13.