OWNER'S MANUAL LOCK-N-LOAD ® POWER CASE PREP CENTER
Lock-N-Load® Power Case Prep Center PARTS LIST Item No. Production Part No. Qty. Description Item No. Lock-N-Load® Power Case Prep Center EXPLODED VIEW 1 2 Production Part No. Qty.
Instructions for Power Case Prep Center: Lock-N-Load® Power Case Prep Center OVERVIEW Secure the Hornady® Lock-N-Load® Power Case Prep Center to your reloading bench with four 1/2" diameter bolts, nuts and washers. Select a bolt length based on the dimensions of your reloading bench. Thank you for purchasing the Hornady® Lock-N-Load® Power Case Prep Center. Please read these instructions before using this machine. If you have any questions about this machine, contact us at 1-800-338-3220.
Loosen the Main Adjustment Knob (approximately a half turn) and turn the Main Adjust Handle counterclockwise until the case mouth is approximately 0.5" above the trimmer pilot with the T-handle in the up position 5 Tighten the Main Adjustment Knob and lower the T-handle to determine how much fine adjustment is needed until the case mouth makes contact with the trimmer cutter. primer pocket use the wire brush to remove powder residue from the case neck.
P.O. Box 1848, Grand Island, Nebraska 68802-1848 308-382-1390 • 800-338-3220 • Fax: 308-382-5761 www.hornady.com • Hornady.
