LOCK-N-LOAD® CONTROL PANEL Deluxe Control Panel Item No. 044650 Standard Control Panel Item No.
TABLE OF CONTENTS Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Items in Box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Setup and Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SETUP AND OPERATION CONTROL PANEL SETUP (Deluxe & Standard models) 1) Align wire harness with connector on back of the Control Panel. Firmly press wire harness into Control Panel while supporting Control Panel. 1 2) Slide Control Panel Mounting Bracket onto the Case Feeder Tube. 3) Place Thumbscrew through Control Panel Mounting Bracket and tighten Thumbscrew. 3 NOTE: Do not overtighten thumbscrew. 4) Plug 12V power supply into input power jack on the wire harness.
COUNTER AND SLIDE DETECT SENSOR SETUP (Deluxe & Standard models) 1) Verify reloading press is securely mounted to bench with two bolts. Remove the right bolt near the primer feed/subplate, and insert the bolt through the Counter Bracket. Rotate the bracket until the sensor levers align with the subplate and primer slide. NOTE: It is helpful to use the Primer Follower to lock the Primer Slide back to help set the Primer Slide Switch. 1 2 2) Tighten the bracket down once the Sensors are aligned.
POWDER LEVEL CHECK SETUP (Deluxe model only) 1) Place the Powder Level assembly into the powder hopper. 2 2) Locate the wire lead for the Powder Detect Sensor and plug the wire harness into the sensors. 3) Verify the wire harness is plugged in correctly by activating the sensor and verifying the corresponding light turns from green to red on the Control Panel. 4) Adjust the Stop up or down on the Powder Float to the desired level by sliding the o-rings on each side of the Stop up or down.
7) Place an empty case under the Powder Safeguard Die and cycle the press until resistance is met. The press should not cycle on an empty case. Remove case from press before proceeding. 8) Place a double-charged case under the Powder Safeguard Die and cycle the press until resistance is met. The press should not cycle on a double powder charged case. Remove case from press before proceeding.
NOTE: If mounting on a Dillon press, please contact Hornady at 1-800-338-3220 and request part number 399274. 4) 3 4 Lightly tighten the bracket down using a 1⁄16” hex wrench and a ¼” open end wrench on the bottom 4-40 Screw and nut. 5) Adjust the Stop up or down on the Primer Follower rod to the correct level by sliding the o-rings on each side of the stop up or down. OPERATION • When the level of primers become low, the stop on the top of the Primer Follower Rod should trip the sensor.
WARRANTY Hornady electronic components are covered by a one-year warranty from the date of purchase. All tool return claims must have a Return Authorization (RA) number assigned before acceptance at our facility for further examination. Please DO NOT send tool items without obtaining a RA number from our customer service staff. All tool warranty claims are handled on a case-by-case basis. In order to initiate a claim, please contact our Customer Service Technicians at 800-338-3220.
