Manual

Lock-N-Load
®
AP
™
Pistol Bullet Feeder
OVERVIEW
Your new Lock-N-Load
®
AP
™
Pistol Bullet Feeder has been packaged to ensure minimal vibration and damage during transportation.
Remove all the parts from the packing box (see page 2) and spread them over a large flat surface. Refer to the parts list and exploded view
on the previous pages and check to make sure all necessary parts are identified.
This manual provides step-by-step instructions that make set-up and operation easy and understandable.
Tools needed for assembly and set-up:
• 7/16" End Wrench
• 3/16" Hex Wrench
• 1/4" Drill Bit
• Electric Drill
- 28 -
ASSEMBLY
ASSEMBLY: PISTOL BULLET FEEDER