Manual

Maintenance of the Lock-N-Load A/P Case Feeder

As with all equipment, proper and routine maintenance will provide smooth operation

and a longer life for your reloading press and Case Feeder. At the end of each reloading

session, wipe off all spilled powder, any dirt, etc., from the press. Check all moving parts

for dirt or spilled powder and remove with a clean rag.

Tips for trouble-Free operation

Problems Solutions Step

Cases are hitting the back corner

of the shell plate when feeding

into the shell plate.

Slow timing down or Re-

adjust V-Block location 13

Cases are not feeding into the

shell plate far enou

Speed timing up or

Usin

the wron

V-Block 13

Cases are tipping when going into

the shellplate

Re-adjust V-Block

location 13

Cases are falling on top of the V-

Block

Re-adjust the Bracket,

Square Tubing 5

Drop tube is tight against the AP

Frame; will not allow changing of

tubes

Re-adjust the Bracket,

Square Tubin

Cases are falling mouth first out

of the bowl

Close the door

ustment 16

Cases are getting caught in the

open hole on the bowl

Open the door

adjustment 16

The shell plate is hitting the V-

Block when it's rotatin

Lower the Cam Wire 13

Chart 4: Trouble free operation.