Manual

15
Step 9: Case escapement bracket assembly.
See Figure 9 for details.
Figure 9: Assembling Case escapement bracket on square tubing.
• Put a ¼” Flat Washer (#48) on the ¼-20 X 1 ½” Cap Screw (#70).
• Slide the Cap Screw (#70) thru the Square Tubing and thread the Hex Nut (#26),
on approximately the length of the nut.
• Slip the Case Escapement Body (#29) over the Cap Screw so the Hex Nut (#26) is
in the slot on the back of the Case Escapement Body. (#29)
• Slip the Cam Wire (#43) into the Cam Wire Support (#31).
• Tighten the Cap Screw (#70) while holding the Bracket level with the top of the
frame.
¼-20 x 1 ½” Cap Screw (Full Size)