Horizon MH50 Quick Start Guide
Getting Started： Thank you for choosing the 4G MiFi. Note: This User Guide provides the basic operations of the Horizon MH50.
Device overview 1. 2. 3. 4. 5.
6. 7. 8. 9. 10.
Display and Icons Icon Description Signal and Roaming status icon Network mode icon Data flow icon Wi-Fi signal and number of access users Thenumber of unread message，maximum is 100 Battery capacity icon, if battery capacity is lower than 25%, this icon is red. DataStatistics, used/total WPS status indicator Download and upload Data Speed Installing the SIM Card Following the instruction to install your SIM card: 1. Remove the SIM card from the outer card, being careful not to touch the gold contacts. 2.
Note: Do not remove SIM card when the device is powered on since this may damage the card and thedevice. Do not bend or scratch your SIM card. Avoid exposing your SIM card to static electricity, water or dirt. Inserting and Charging the Battery 1. Remove the battery cover and align the battery contacts with the terminals in the battery compartment as shown. Push the battery down until it clicks into place. 2.
Removing the SIM Card 1. Turn the power off. Remove the battery cover and take out the battery. 2. Gently remove the SIM card from the SIM card slot Setting up Wi-Fi connection 1. Press and hold the “power” button for 3 seconds until the welcome logo is displayed on the LCD, and Wi-Fi is on. 2. Use your terminal to search the wireless network connection with the Wi-Fi’s SSID of “4G-MIFI-2.4G-xxxx”or“4G-MIFI-5G-xxxx” and click “Connect”.
Note: The default user name is admin; the default password is admin. You can also find the label for default log in username and password printed on the device label by removing the back cover and battery. How to change the SSID &Password 1. While your computer or other device terminal is connected to the hotspot, log in to http://192.168.1.1 or http://device.WebUIin an internet browser using the default username and password. 2.
Q: What to do if I forgot my Wi-Fi password? A: 1. you can find the Wi-Fi password in the Wi-Fi Info page on the LCD. 2.you can also reset the device to factory defaults by press the reset button for5 seconds. The default password is the last 8 digits of your device IMEI which is also listed on the SSID label under the back cover of the device. Q: Data connection failed. A: You have no net work coverage. Try moving location until you get good reception.
Do not use your device immediately after a sudden temperature change. In such case, it will produce moisture inside and outside your device. Wait until it becomes dry. • Handle your device carefully. Do not drop, bend, or strike it; your device may get damaged. • No dismantling by non-professionals and only qualified technicians can undertake repair work. • An operating temperature range of -10°C - +45°C and humidity range of 5% - 95% are recommended.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
