Owner's Manual

Revision - 8 of 17
SECTION 4 – Installation
1. Place the provided loop clamps in the approximate mounting location on the roll
bars. The Audio Mini brackets will rest on the loop clamps and be tightened in the
following steps. See Figure 2.
Figure 2: Approximate locations of the loop clamps.
2. Remove the factory bolt from the front cross member as indicated in Figure 3.
The bolt will be reused. Note: Driver side shown. (Passenger side similar)
Figure 3: Remove the factory cross member bolt.
3. Place the driver’s side bracket on the inside of the cross member. Use the factory
bolt and loosely tighten it until the bracket is secured to the loop clamp in the
following steps. Verify correct orientation of the mounting bracket. See Figure 4.
Note: Driver side shown. (Passenger side similar)