Owner's Manual

Revision - 10 of 17
5. Using an assistant, hang the Audio Mini off-road sound system on the brackets
using the supplied ¼”-20 bolts and washers (loosely tightened). Note: The sound
system weighs up to 25 lbs. Since you will have to lift and bolt each end, it is
helpful to have an assistant for this step. See Figure 6 and Figure 7.
Figure 6: Install the ¼”-20 bolts and washers to mount the Audio Mini to the brackets.
Figure 7: Loosely install the sound system on the mounting brackets.
6. Tighten both loop clamp bolts and both front cross member bolts to secure the
brackets to the roll cage, once you have the Audio Mini in your desired position.
See Figure 4 and Figure 5.
7. Tighten the 4 mounting bracket bolts after achieving the desired viewing position
relative to the roof or roll cage. Slots in the brackets allow for adjustability to
achieve your desired viewing position. See Figure 8.