Installation Guide

* The red wire goes to the positive battery
terminal. Connect it first.
*The orange wire goes to an ignition controlled
+ lead. (Orange wire with white stripe found
under the seat.)
*The black wire goes to the negative battery
terminal.
Note: Call us or ask your mechanic if you
are not confident about wiring.
(3) Position the windshield in place and start
the windshield screws from the outside, with a
stainless washer on each screw. On the inside,
place a chromed acorn nut and chromed washer
on each screw, placing a drop of Loctite inside
each nut. Placing the Loctite in the nut will
help prevent it dripping on painted surfaces or
the windshield itself, as Loctite will attack
some plastics and paints. Tighten the windshield screws finger-tight. Snug the windshield
nuts to about 15-20 inch pounds, just enough to not flex the fiberglass flanges into the
slots and holes in the shield. The Loctite will keep them from coming loose. After paint,
use the Loctite on the 6 screws that hold the front & inner fairing halves together and do
not over tighten.
______________Important safety information-please read!!!_____
Any modification like adding a fairing, extended controls, different handlebars, etc., will
have an effect on your bike’s handling. That doesn’t mean bad, just different. Take
some time to get to know your bike after installing your fairing. The decreased wind felt
by the use of a fairing can affect your perception of speed, leading you to possibly drive
faster than you are aware of. Crosswinds and passing large vehicles will have an effect
because of the larger front surface area. Handling in parking lots may feel slower.
Last but definitely not least - take the time BEFORE your first ride to become familiar
with your new radio’s controls. Set the preset channel buttons, adjust the volume and
tone, and know how to turn it off & on without having to take your eyes off the road.
Your new fairing will give you miles of smiles and get you there less fatigued-but not if
you plow into something while playing with the radio!!!!
Note: If your stereo includes a CD player, the player may skip due to
vibration of your bike.
Installation Items Included
8-piece Mounting Bushings set
(1) Power Cord (w/fuse if optional 12-volt Power Socket equipped)
(2) Ring Terminals
(1) “Tap-In” splice connector RED
(1) Crimp-on end connector
(2) 5/16 ID, ½ OD, ½ long spacer
(2) 5/16 ID, ½ OD, ¾ long spacer
(2) 5/16 ID, ½ OD, 7/8 long spacer