Owners manual

F2A
1. Remove access panel in the center
of dash on passenger side next to
auxiliary switches.
2. Remove connector (Fig. 1 / A) from
back of access panel.
3. Plug the Brake control connector
into the vehicle connector (Fig. 2).
4. Plug mating end of the Brake control
connector into the brake control.
5. Test all functions.
Wire to brake control by
function only. Color coding
is not standard among all
manufacturers. To ensure proper
installation, read brake control
instructions thoroughly.
47855
FIG. 1
A
FIG. 2
WIRE CODE
White wire------ Ground
Blue wire-------- Electric brake
Black wire------ Battery
Red wire-------- Stop lamp switch
1. Remove access panel in the center
of dash on passenger side next to
auxiliary switches.
2. Remove connector (Fig. 1 / A) from
back of access panel.
3. Plug the Brake control connector
into the vehicle connector (Fig. 2).
4. Plug mating end of the Brake control
connector into the brake control.
5. Test all functions.
Wire to brake control by
function only. Color coding
is not standard among all
manufacturers. To ensure proper
installation, read brake control
instructions thoroughly.
47855
FIG. 1
A
FIG. 2
WIRE CODE
White wire------ Ground
Blue wire-------- Electric brake
Black wire------ Battery
Red wire-------- Stop lamp switch
1. Remove access panel in the center
of dash on passenger side next to
auxiliary switches.
2. Remove connector (Fig. 1 / A) from
back of access panel.
3. Plug the Brake control connector
into the vehicle connector (Fig. 2).
4. Plug mating end of the Brake control
connector into the brake control.
5. Test all functions.
Wire to brake control by
function only. Color coding
is not standard among all
manufacturers. To ensure proper
installation, read brake control
instructions thoroughly.
47855
FIG. 1
A
FIG. 2
WIRE CODE
White wire------ Ground
Blue wire-------- Electric brake
Black wire------ Battery
Red wire-------- Stop lamp switch
1. Remove access panel in the center
of dash on passenger side next to
auxiliary switches.
2. Remove connector (Fig. 1 / A) from
back of access panel.
3. Plug the Brake control connector
into the vehicle connector (Fig. 2).
4. Plug mating end of the Brake control
connector into the brake control.
5. Test all functions.
Wire to brake control by
function only. Color coding
is not standard among all
manufacturers. To ensure proper
installation, read brake control
instructions thoroughly.
47855
FIG. 1
A
FIG. 2
WIRE CODE
White wire------ Ground
Blue wire-------- Electric brake
Black wire------ Battery
Red wire-------- Stop lamp switch
1. Remove access panel in the center
of dash on passenger side next to
auxiliary switches.
2. Remove connector (Fig. 1 / A) from
back of access panel.
3. Plug the Brake control connector
into the vehicle connector (Fig. 2).
4. Plug mating end of the Brake control
connector into the brake control.
5. Test all functions.
Wire to brake control by
function only. Color coding
is not standard among all
manufacturers. To ensure proper
installation, read brake control
instructions thoroughly.
47855
FIG. 1
A
FIG. 2
WIRE CODE
White wire------ Ground
Blue wire-------- Electric brake
Black wire------ Battery
Red wire-------- Stop lamp switch