Product Info

E-mail:sales@hoperf.com Rev1.0
RFM95C
B
www.hoperf.com
ATTENTION
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) This device and its antenna(s) must not be colocated with any other transmitters except in accordance with FCC
multitransmitter product procedures. Referring to the multitransmitter policy, multipletransmitter(s) and module(s)
can be operated simultaneously without C2P.
3) For all products market in US, OEM has to limit the operation channels in 915MHz by supplied firmware
programming tool. OEM shall not supply any tool or info to the enduser regarding to Regulatory Domain change.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna
while this end product is installed and operated. The end user has to be informed that the FCC radiofrequency
exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also be informed that any
changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this
equipment.
If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be available
in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains FCC ID: 2ASEORFM95C ". If the
size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be available on the
label: This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
HOPEMICROELECTRONICS CO.,LTD
Add: 2/F, Building3, Pingshan Private Enterprise
Science and Technology Park, Xili Town, Nanshan
District
Tel: 86-755-82973805
Fax: 86-755-82973550
Email: sales@hoperf.com
Website: https://www.hoperf.com
http://www.hoperf.cn
This document may contain preliminary information and is subject to change by
Hope Microelectronics without notice. Hope Microelectronics assumes no
responsibility or liability for any use of the information contained herein. Nothing
in this document shall operate as an express or implied license or indemnity
under the intellectual property rights of Hope Microelectronics or third parties.
The products described in this document are not intended for use in implantation
or other direct life support applications where malfunction may result in the direct
physical harm or injury to persons. NO WARRANTIES OF ANY KIND,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIESOF
MECHANTABILITY
ORFITNESSFOR
A
ARTICULARPURPOSE,AREOFFER
EDIN THISDOCUMENT.
©2018,HOPEMICROELECTRONICSCO.,LTD.Allrightsreserved.