Users Manual

FCC Statements
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated
RF Module. For 15 B (§15.107 and if applicable §15.109) compliance, the host
manufacturer is required to show compliance with 15 while the module is installed and
operating.
Furthermore the module should be transmitting and the evaluation should confirm that the
module's intentional emissions (15C) are compliant (fundamental / out-of-band). Finally
the integrator has to apply the appropriate equipment authorization (e.g. Verification) for
the new host device per definition in §15.101.
Integrator is reminded to assure that these installation instructions will not be made
available to the end-user of the final host device.
The final host device, into which this RF Module is integrated" has to be labeled with an
auxiliary label stating the FCC ID of the RF Module, such as "Contains FCC ID:
2ASEO-HM-BT2204
"This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may
cause undesired operation."
"Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment."
the Integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the
module integrated into the host device.