User guide

2. Install the non-drive side cup (without bearing tted).
4. Install the non-drive side bearing (continued).
3. Install the centre tube. 4. Install the non-drive side bearing. Ensure the bearing is tted with the green seal outside.
6. Install drive side outer seal ring.
5. Install non-drive side outer seal ring.
Your bottom bracket is now fully installed and ready for the continued installation of your crank set.
Issue 01 - 03/2014
Non-drive side cup is installed
Centre tube is installed
Unscrew the nut and remove the tool
Non-drive side cup is now
fully ush with the BB shell
Non-drive side bearing is installed
Non-drive side bearing is now fully
pressed into the non-drive side cup
Hold this end stationary
using a 27mm spanner
Tighten the nut using a 19mm spanner
until the non-drive side cup is pulled fully
ush with the bottom bracket shell
Non-drive side cup
(Item No. 4)
Apply grease to the internal
surface of the B.B. shell
30mm bearing adapter
(from kit HTT185)
30mm Bolt-in Centre Tube
(Item No. 3) BB006-3
Apply grease to the threads of
the centre tube and the mating
faces of the centre tube and cup
30mm hexagon adapter
(from kit HTT185)
Fit the 30mm hexagon adapter
over the hexagon on the tool
head to drive the centre tube
Tighten the centre tube
using a 27mm spanner.
Tightening torque 27-34 Nm
Tightening torque:
27-34 Nm ( 20-25 ft. lbs. )
30mm Bottom Bracket Bearing
S71806 (Green seal outside)
30mm bearing adapter
(from kit HTT185)
30mm bearing adapter
(from kit HTT185)
Unscrew the nut and remove the tool
30mm Outer Seal Ring
BB003-4
30mm Outer Seal Ring
BB003-4
Apply grease to the external faces of the bearing
before installing the outer seal ring
Apply grease to the external faces of the
bearing before installing the outer seal ring
Hold this end stationary
using a 27mm spanner
Tighten the nut using a 19mm
spanner until the non-drive side
bearing is pulled fully into position