Instructions / Assembly

6
Press sides of solution tank to release tank
from steamer.
Squeeze tabs on side of tank to slide tank out of 
steamer as shown (3.3).
Remove cap from the top of tank (3.4). 
DO NOT MIX  HOOVER
®
MULTI-PURPOSE
DISINFECTANT OR HOOVER
®
MULTI-
PURPOSE CLEANER WITH ANY OTHER
CLEANING SOLUTION.
Fill the tank with recommended Hoover 
®
Multi-
Purpose Disinfectant or Hoover
®
Multi-Purpose
Cleaner using funnel and measuring cup.
Replace cap ensuring that it is fully sealed. 
Replace tank by sliding it into opening and 
applying light pressure to the back of the tank
until tabs on side of the tank lock into body
of steamer.
Adjust clean control dial by turning the dial 
(3.5) to the desired setting, which will
automatically dispense the solution when
pressing the trigger. Turn to the “off” position
if no Hoover
®
solution is desired.
REMOVING AND FILLING SOLUTION TANK
3.3
How to Use: Steamer
3
3.4
WARNING
Turn off, unplug, and allow steamer to cool before servicing or filling tank. Do not clean over floor
electrical outlets. Use only with Hoover
®
Multi-Purpose Disinfectant or Hoover
®
All-Purpose Cleaner.
!
!
Place the appliance on a level platform. If you  are
filling the clean water tank during or after use,
see “Refill Water During Operation” instructions
below. After you have ensured the steamer has
cooled and pressure has been released, the
water fill safety cap should turn freely for removal.
Unscrew the water fill safety cap counter-
clockwise (3.1), and insert funnel.
Add 300ml clean water into the measuring cup, 
as indicated on cup, and pour the water into the
tank (3.2). (Max. capacity of the tank is 300ml. Do
not overfill the tank to allow space to be left at
the top).
3.1
3.2
FILLING CLEAN WATER TANK
Use caution when removing water fill safety cap.
Even when cap is able to be turned the steamer
may still be hot, especially the metal ring.
CAUTION
!
!
3.5
Do not leave clean control dial in between settings.
Make sure the dial clicks into the proper setting
before use.
CAUTION
!
!

Re-install the water fill safety cap in a clockwise 
direction and tighten until completely sealed.