Owner’s Manual ™ The Easy to Use Deep Cleaner with automatic tool conversion Review this manual before operating deep cleaner Plus Models Deluxe Models These models are included in this manual SteamVac™ Deep Cleaner cleans carpet fibers by applying hot tap water and cleaning solution. www.hoover.
Fill in and Retain This HOOVER deep cleaner is designed for deep cleaning carpet, rugs, carpeted stairs and upholstery. The model and serial numbers are located on the data label on the back of the handle. For your personal records, please enter the COMPLETE model and serial numbers in the spaces provided and retain this information. Your deep cleaner is model and has serial number It is suggested that you attach your sales receipt to this owner s manual.
Grounding Instructions D A B F G E DANGER- C Improper connection of the equipmentgrounding conductor can result in the risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
The assembled cleaner will look like this drawing (Plus model shown). Assemble handle 1-3 1-2 A Attach upper handle Remove clean solution tank (upper tank) from deep cleaner. With cord hook (A) to back of deep cleaner, push upper handle down onto lower handle. Push bolts into holes on front of handle. If bolts will not go through hole easily handle is not pushed completely down.
1-10 1-12 1-11 F F D E Slide rack down into place. Insert screw at (D) and tighten with a Phillips screwdriver. Storing hose & tools Store hose on rack by first positioning hose in front section of holder. Continue wrapping hose under lower hook (E). Snap hose end fully into holder (F). The hose end must be pushed completely down into holder (F) to ensure maximum suction when cleaning floors. 1-13 1-14 1-15 Position tool in holder at base of cleaner and snap it into place as shown at arrow.
2-2 2-3 2-4 C D A B ON/OFF pedal & Handle release pedal Step on pedal (A) to turn deep cleaner on. Step on pedal again to turn deep cleaner off. Step on pedal (B) to lower handle to operating position. Handle does not lock into a single position but “floats” to allow convenient operation. Cleaning mode indicator To transport Indicator will show a green window next to FLOOR (C) when handle is in the operating position for cleaning carpet rugs and bare floors.
2-10 2-12 2-11 5 OUNCES/ 150 ml A The tanks Clean solution tank (upper tank) The clean solution tank holds the cleaning solution that is to be dispersed onto the surface to be cleaned. How to fill Disconnect deep cleaner from electrical outlet. Place deep cleaner handle in the upright, locked position. To remove tank, press down on handle and pull forward. Carry tank to a sink. Rotate tank cap counterclockwise and lift up to remove cap. Turn cap (A) upside down to serve as a measuring cup.
2-17 2-18 For full suction, it is important that the recovery tank lid is properly secured before cleaning. UNLOCK Raise tank handle to carrying position to place it into base of cleaner. Move handle completely forward to lock tank into place (see Fig. 2-17). Raise handle to carrying position (straight up) to unlock tank from base of deep cleaner. Lift tank from deep cleaner and carry it to a sink or drain. 3. How to clean Before you begin cleaning a.
To clean nozzle you (second wet stroke). Release trigger and slowly push deep cleaner forward over area just sprayed with solution (dry stroke). Then slowly pull deep cleaner back toward you without squeezing trigger (dry stroke). 3-2 If lint or other debris becomes lodged in nozzle, do not attempt to remove nozzle cover. Pour one to two cups of clear water on a non-carpeted floor. Do not pour water onto a wood floor. Pick up water with your ‘SteamVac’ deep cleaner.
3-5 3-6 7. Pre-spray the carpeted stair by holding the tool about one inch above the carpet and push it forward while pressing the trigger (equals one wet stroke). 8. Position tool against the riser and slightly press it into carpet pile. Press the trigger and pull the tool slowly over the carpet (second wet stroke). Release trigger at end of stroke. 9. Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger (dry stroke).
4. Maintenance 4-2 4-1 Removable brushes A Your deep cleaner is equipped with removable brushes for easy cleaning. B B To remove brushes Disconnect cleaner from electrical outlet. To prevent possible leaking, remove clean solution tank and recovery tank. Set tanks aside. 4-3 Press handle release pedal to lower handle. Turn cleaner over so bottom is facing up. Grasp inner portion of brush (A) and pull brush assembly out slightly to reveal latches (B).
5. If you have a problem If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below.
