Other Document

15
EN
 Rotating the programme selector in both
directions it's possible to select the
desired drying programme.
 To cancel the selections or switch off the
appliance rotate the programme selector
on OFF (remember to unplug the
appliance).
 Press the START/PAUSE button to start
the programme set with the programme
knob (the corresponding indicator light
will light up).
 Moreover, if you want to modify the
chosen programme, press the desired
options buttons and then press START/
PAUSE button to start the cycle.
 After switching on the appliance, wait a
few seconds for the programme to start
running.
PROGRAMME DURATION
 When a programme is selected the
appliance calculates the time to the end
of the selected programme based upon a
standard loading but, during the cycle, the
appliance corrects the time to the
humidity level of the load.
PROGRAMME END
 The "END" indicator light will light up at
the end of the programme, it is now
possible to open the door.
 At the end of the cycle, turn off the
appliance by turning the programme
selector to the OFF position.
PAUSING THE MACHINE
 Press the START/PAUSE button (the
corresponding indicator light will flash,
showing that the machine is paused).
 Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
 To cancel the programme, turn the
programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
 Appliance start time can be set with this
button, delaying the start by 3, 6 or 9
hours.
DELAY START button
The programme selector must
ALWAYS be put in the OFF
position at
the end of the
drying cycle before a
new one can be selected.
Only the options compatible with the
set programme can be selected.
Close the porthole BEFORE pressing
the START/PAUSE button.
START/PAUSE button
PROGRAMME SELECTOR with
OFF position
WARNING
Don’t touch the buttons while inserting
the plug because the machines
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn’t work property. In
this case, remove the plug and repeat
the operation.