User's Guide

!
EN
27
! The washer dryer will calculate the time
needed for drying and the level of
moisture remaining in the laundry,
according to the load and drying type
selected.
! Check that the tap is turned on and that
the discharge hose is positioned
correctly.
! Press the START/PAUSE button (the
display will show the drying time
remaining).
! The drying programme indicator will be
on, until the cool down phase begins and
the corresponding indicator is on.
! When the programme is finished the word
"End" will appear on the display. After
5 minutes the appliance will go into
standby mode (on certain models, the
display will show two lines).
! Switch off the machine by turning the
programme selector to the OFF position.
! Open the door and remove the laundry.
! Turn off the tap.
CANCELLING THE DRYING PROGRAMME
! To cancel the drying programme, press
and hold the DRYING SELECTION
button for about 3 seconds.
In order to ensure the correct operation
of the appliance, it is advisable not to
interrupt the drying phase unless it is
absolutely necessary.
By selecting the wool drying
programme, it's not possible to select
a degree of dryness different from the
default one.
WARNING:
Do not dry articles with special
padding (e.g. quilts, quilted anoraks,
etc.) and very delicate fabrics.
If garments are drip/dry, load less
items to prevent creasing.
The appliance calculates the time to
the end of the selected programme
based upon a standard loading.
During the cycle, the appliance
corrects the time according to the size
and composition of the load.
During the drying phase the drum will
accelerate to a higher speed to
distribute the load and to optimize the
drying performance.
WARNING:
After cancelling the drying programme,
the cool down phase will begin and you
must wait for about 10/20 minutes
before opening the door.