Manual

The assembled cleaner wilt look like Assemble handle
this drawing.
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
A
!
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle. Push bolts into holes on front of ha_
die. if bolts will not go through hole easi-
ly handle ta not pushed completely
down.
Place nuts in recessed areas on back of
handle. Hold each nut in place while
tightening each bolt securely with a
Phillips screw driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
When handle sections are completely
together, squeeze trigger (B) on upper
handle to snap tripqer rod tn place.
Replace clean solution tank (upper
tank) by positioning bottom first. Press
on tank handIe to snap top of tank into
place.
Press cord into cord clip on back of
handle. Pull cord tight.
Attach hose clip
Push tab on side of clip into hole on
side of handle.
Pivot clip and push other tab into hole
at back of handle to lock into place.