Manual

n for scrubbing or Off if
ing Is not desired.
Dry hands and plug deep cleaner into
a properly groundedoutlet.
Step on handlerelease pedaland lower
handle to operatingposition;turn deep.
cleaner ON.
To release solution,presstrigger.Slowly
move deep cleanerforward and back-
ward over area to be cleaned.
To pick up dirtysolution,releasetrigger
and slowly movedeep cleanerover
area wheresolutionhasjust beendis-
pensed.Use both forwardand reverse
strokes.
Emptyrecoverytank when the motor
sound becomeshigher pitchedand
there is a lossinsuction(see
"Automaticshut-off', page7)
When finishedcleaning,follow 'After
cleaning"instructionson pages9-10.
Removeattachmentfrom nozzle and
rinsein clearwater. Do not remove
plastio screen or foam from attach-
men*,.
The poweredhandtool (Ultramodels.)
has rotating brushes for extrascrubbing
actionon smallcarpetareas,carpeted
stairsand upholstery.
The stair/upholsterynozzlehasa built-in
brushto helpprovidethescrubbing
actionsomespots may needfor
removal.
Theutilitynozzle (somemodels)canbe
usedfor carpetand upholsteryinvehi-
cles.
How to attach tool
Disconnectdeep cleanerfrom electri-
cal outlet.
Placehandlein uprightpositionand
removehosefrom rack.
J_Connect poweredhandtool(A)'or
stair/upholsterynozzleorutility
nozzle(8) toend of hoseby slidingit
ontoconnectoruntilthetab(C) locksit
securely.
Usingyour thumb,pushforwardand
upon the latch(D) to removetool as
shown.
Followtheinstructionson pages11-12
for theappropriatecleaningtask.
C
Before using tool
It may be necessaryto removeair from
the system(=pdme the pump")so the
clean solutionwillflow tothetoot.Follow
these steps:
1. Attachtool to hoseand turnthe deep
cleaner ON.
?,,Putthetool on a hardsurfaceor
againstyour handto blockoff the suc-
tion,
3. Wait a few seconds(cantake up to
15 seconds).Then squeezethe trigger
and begin cleaning.
Followtheinstructionson pages11-12
for the appropriatecleaningtask.
4. Disconnectdeep cleaner from electri-
cal outlet.
5. Drainsolutiontube (locatedinside
hose)by pointingend of hosein sink
and pressingtrigger.
6. Proceedwith steps c. d, and e, for
'After cleaning"on page 9.
After using tool
1. Followstepsa and bfor *Afterclean-
ing" on page 9.
2. Rinsetooland hoseby filling sink
witha smallamountof water,Turn
deep cleanerON and pickupthe
waterwiththe tool,
[_. Drain hose by turning deep
cleanerON and holdingend of
hose upfor severalseconds,Do not
presstrigger,
Read "Before you begin cleaning"
instructionson page 9.
Placehandle,in uprightposition.
Agitator brushes will not rotate while
handle is in upright position.
Fill cleansolutiontankwith HOOVER
Carpet/UpholsteryDetergentaccording
to instructionson pages7 and 8, Attach
tootto end of hose,
Hose length may require that machine
be placed at the top of the stairsto clean
upper half of stairway and at bottom of
stairs to clean lower hall
To prevent machine from failing, use
extra caution when cleaning on stairs.
Do not place deep cleaner on stairs.
Do not point tools toward people or
pets. Dry hands and plug deep cleaner
into a properly grounded outlet.
Turn deep cleaner ON.
['_ Pre-spray the carpeted stair by
holding the tool (A) or (B) about
one inch above the carpet and push it
forward while pressing the trigger
(equals one wet stroke).
Position tool againstthe riserand slightly
pressit into carpet pile. Press the trigger
and pullthe toolslowly over thecarpet
(secondwet stroke). Releasetrigger at end
of stroke.
Continued -@'11