Manual

If you have a problem
This appliance was inspected thoroughly and was in good
operating condition when it was shipped from the factory,
If a minor problem occurs, it usually can be solved quite
easily when the cause is found, Therefore, this check list is
provided for your convenience,
Possible cause Possible solution
Machine won't run
1. Not firmly plugged in. 1. Plug unit in firmly.
2. No voltage in wall 2. Check fuse or breaker.
plug.
3. Blown fuse/tripped 3. Replace fuse/reset
breaker, breaker.
Low suction
1. Recovery tank full/ 1. Empty recovery tank.
automatic shut-off
engaged.
2. Lint on filter(s)/ 2. Clean filter(s)/hose
in hose conection connection (see "After
on top of cleaner cleaning")
lid.
Clean solution won't dispense
1. Solution tank empty. 1. Refill tank.
Storage
Before storing;
• Empty solution and recovery tanks and thoroughly rinse
them with clean water
• Allow parts to air dry before latching cleaner lid to tanks
,/0
Wrap cord around handle as shown.
Do not store cleaner with solution in tanks.
Lubrication
The motor is equipped with bearings which contain sufficient
lubrication for the life of the motor The addition of lubricant
could cause damage Do not add lubricant to motor
bearings.
Service
To obtain approved HOOVER service and genuine
HOOVER parts, locate the nearest Hoover Factory
Service Center or Authorized Hoover Warranty Ser-
vice Dealer (Depot) by:
• checking the Yellow Pages under "Vacuum
Cleaners- Household" OR-
• checking the list of Factory Service Centers
provided with this cleaner OR -
• calling 1 8009449200 for an automated
referral of authorized service outlet locations
(U,S, only),
Do not send your cleaner to The Hoover Company in
North Canton for service, this will only result in delay,
If further assistance is needed, contact The Hoover
Company Consumer Response Center, North Canton,
Ohio 44720 Phone: [phone]
In Canada, contact Hoover Canada, Burlington, Ontario
L7R 4A8, Phone: [phone]
Always identify your cleaner by the complete model
number when requesting information or ordering parts,
(The model number appears on the data label near the
back of the cleaner handle,)