Manual

Picking up spills
Your cleaner may also be used to pick up small liquid spills on
carpet, upholstery or bare floors, Depending on the amount of
the spill, it may be necessary to empty the recovery tank often,
For best results, pick up spills immediately by placing the nozzle
just above the spill and suction up any residue on top of the
carpet or bare floor, If the spill remains, place the nozzle in front
of the spill, pull the nozzle very slowly over the spill initially with
suction only, Repeat with spray and suction,
Although no cleaning solution can completely remove all spots,
they can be treated by following the instructions provided by the
manufacturer of the carpet, upholstery or bare floor surface
being cleaned,
Do not use the 'SteamVac Jr.' compact spot cleaner to pick
up flammable or combustible liquids or chemicals.
After cleaning
a, Allow carpet or upholstery to dry, To help prevent matting
and resoiling the carpet, keep children and pets away from
surface until it is completely dry,
b Rinse nozzle and hose by filling sink with a small amount of
water, turning cleaner ON, and picking the water up with the
nozzle,
Drain hose by turning cleaner ON and holding nozzle up for
several seconds, Do not press trigger,
Drain solution tube (located inslide hose) by disconnecting
cleaner from electrical outlet, placing nozzle below the cleaner,
and pressing trigger,
Clean tanks
LATCH
J
C, Unlatch cleaner lid by pulling latches outward on both sides
of cleaner, Lift off lid,
Rinse tanks with clear water and let air dry,
Clean filters
FILTER
d, Remove debris from recovery tank filter and rinse with clean
water, Filter may be removed for cleaning,
SPOUT
LINT SHELF
e Remove any debris from lint shelf on cleaner lid,
I
'
/ /
f, Remove debris from screen filter located at bottom of cleaner,
Be careful not to poke through screen filter when cleaning,
WAND HOLDER CLIP CONNECTOR
g, Occasionally, debris may become lodged on the inside of the
hose connector on the top of the cleaner lid.
To clean-out hose connector, lift bottom edge of wand holder
clip and remove clip, Remove debris, Snap clip back into
position,
Allow all parts to air dry before securing cleaner lid to tanks for
storage,