Owners manual

4
P/N 302-2 OIL PAN:
WARNING! The 302-2 oil pan is design to use a GM LS “F-Body” windage tray, GM P/N 12558253. Due to the design of the Holley®
oil pump pickup screen, a modification to the windage tray must be made. A cut to provide clearance to the oil pick-up
tube must be made as shown in Figure 6. The cut-out below may be used as a template for the cut.
A full-length windage tray may be used if it is modified to remove the front quarter of the tray and the required cut is made
to provide clearance to the pick-up tube (Figure 6). A very careful check should be made to insure that the oil pick-up
tube has clearance to the windage tray and that the oil pick-up tube mounting bracket seats down properly on the
mounting stud and windage tray without interference.
Figure 6