Owners manual

RIGHT SIDE
1. Remove the spark plugs, dipstick tube, stock exhaust manifold, and air conditioning (if mounted on right side).
2. Starting from below, work the header up through the chassis into position. Check the clearances.
NOTE: It ma
y be necessary to increase clearances. 1) Bend or remove the frame support brace. See Figure A. 2) Trim A-frame bolts flush
with the nuts. See Figure F. 3) Slightly dent the header pipe R-2 according to Figure G (this modification will not affect performance).
Figure F
Figure G
3. Position the gasket and start all bolts. Tighten all bolts evenly.
4. For models with automatic transmissions, check the cooler lines for header clearance. Reroute, as necessary.
5. Replace the spark plugs and dipstick tube.
6. For models equipped with air conditioning mounted on the right side, it is required to modify the mounting bracket for header clearance.
Fabricate two spacers (3/8” approximately) and install using two stock exhaust manifold bolts. See Figure H.
Figure H