Owners manual

NOTE: Some models require the brake line block to be relocated from the side of the frame to the top of the frame to provide maximum
clearance for the header.
4. Place a board under the oil pan and jack up the engine approximately 2 inches.
5. Starting from below, work the header up through the chassis into position.
NOTE:
It may be necessary to modify the motor mount, according to Figure B, if the L-1 pipe does not have sufficient clearance.
Figure B
6. Lower the engine and replace the motor mount bolts.
7. Position the gasket and start all bolts. Tighten all bolts evenly.
8. Replace the spark plugs, oil filter, and clutch linkage (if removed).
9. To remount the air conditioning, modify the stock bracket. 1964-72 models: see Figure C. 1973-74 models: see Figure D.
Figure C Figure D
NOTE: Some 196
8 models will require a fabrication of a 3/4” spacer for the power steering mounting bolt. See Figure E.
Figure E