Installation Sheet

3/4
2. Take out center supports (L) from the rail box, attach center supports (L) to slats by using 2 bolts
(Q), 2 lock washers (V) and 2 flat washers (U). Secure bolts (Q) by using allen wrench (R). (See
diagram 2)
Diagram 2
3 Attach slats (D) to side rails (C), align pre-drilled holes on the slat to holes on the cleat of side rail
(C), using screws (K) to tighten both. (See diagram 3)
Diagram 3
Note: You can change the height of slat by adjusting the height of cleat on side rail as shown in
diagram 4. Remove bolt (I), lock washer (O) and flat washer (J) from the cleat by turning the
bolt (I) with allen wrench (M) in anti-clockwise direction. Adjust the cleat to a desired position,
and then secure lock washer, flat washer, bolt in a clockwise direction by turning with allen
wrench.