Installation Sheet

ManualsBrandsHooker Furniture ManualsBedroomHooker Furniture King Solid Poplar Panel Bed Frame from the Solana Collection

1/4

ASSEMBLY INSTRUCTION

ITEM# 5291-90267 6/6-6/0 Mirrored Panel Headboard

5291-90367 6/6 Wood Panel Headboard

5291-90867 6/6 Upholstered Panel Headboard

5291-90268 6/6-6/0 Panel Footboard

5291-90269 6/6 Rails

5291-90263 6/0 Rails

Caution: Please make sure you have all parts indicated below prior to assembly.

This bed is heavy and can best be assembled with the help of two or more persons.

5291-90267 5291-90367 5291-90867

PS: Here are three headboards that use same footboard 5291-90268 and rails

5291-90269.These beds are in the same way to assemble. Below use 5291-90267 headboard

as example.

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTION ITEM# 5291-90267 6/6-6/0 Mirrored Panel Headboard 5291-90367 6/6 Wood Panel Headboard 5291-90867 6/6 Upholstered Panel Headboard 5291-90268 6/6-6/0 Panel Footboard 5291-90269 6/6 Rails 5291-90263 6/0 Rails Caution: Please make sure you have all parts indicated below prior to assembly. This bed is heavy and can best be assembled with the help of two or more persons.
PAGE 2
See Diagram 2 See Diagram 1 See Diagram 3 See Diagram 5 Please note the hardware bag to assemble side rails to HB&FB is in the box of side rails. Assembly steps: 1. Insert 2 bolts (H) into holes of each side post on Headboard (A) and Footboard (B), attach the end of side rails (C) to bolts (H) on posts by using 2 curved washers (G) and 2 nuts (E), tighten nuts (E) securely with spanner wrench (F).
PAGE 3
2. Take out center supports (L) from the rail box, attach center supports (L) to slats by using 2 bolts (Q), 2 lock washers (V) and 2 flat washers (U). Secure bolts (Q) by using allen wrench (R). (See diagram 2) Diagram 2 3 Attach slats (D) to side rails (C), align pre-drilled holes on the slat to holes on the cleat of side rail (C), using screws (K) to tighten both. (See diagram 3) Diagram 3 Note: You can change the height of slat by adjusting the height of cleat on side rail as shown in diagram 4.
PAGE 4
Diagram 4 You can adjust the height of center supports (L) as shown in Diagram 5 to meet your need by the following steps. 1. Unscrew bolts on center supports (L) with allen wrench (R). 2. Adjust the height of center supports, align the holes on 2pcs of woods and tighten them together with 2 bolts (Q), 2 lock washers (V) and 2 flat washers (U) by turning with allen wrench (R) in a clockwise direction.