User's Manual

※Depending on the operating system, you may need to install drivers or establish
the relevant network connection on your computer before using this function. Refer
to your computer's operating system guide for more information.
※Data transfer may fail with a non-original USB data cable.
7. Warning
Specific Absorption Rate (SAR) information. SAR tests are conducted using standard
operating positions accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands, although the SAR is determined
at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value, in general, the closer you are to a
wireless base station antenna, the lower the power output.
Before a new device can be made available for sale to the public, it must be tested
and certified by the FCC that it does not exceed the exposure limit established by the
FCC,Tests for each device are performed in positions and locations as required by the
FCC. For body worn operation, this device has been tested and meets the FCC RF
exposure guidelines when used with an accessory designated for this product or
when used with an accessory that contains no metal and that positions the device a
minimum of 1.0 cm from the body.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause.
Undesired operation.Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and complies with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur during installation. If
the device does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is suggested to try
to correct the interface by the following measures:
--Reorient or relocate the receiving antenna.
--Increase the distance between the equipment and receiver
--Connect the equipment to an outlet on different circuit to the receiver