Installation Guide

11 / 16 HONG KONG KONING INDUSTRIAL LIMITED
Tel:[phone]
E-mail:[e-mail]
W400/200 SERIES INSTALLATION GUIDE
6) Installing the Inside Panel Antenna(s)
Panel antenna has certain directivity, if it is mounted in wall, preferably in the center of where the
signal needs to be amplified.
If sever antenna is put in ceiling, it can be only put in where in the center of coverage area. but the
signal strength will be little weak and coverage area will be smaller.
Sever antenna can’t “see” the location where panel antenna be mounted and have enough safety
isolation distance.
ꙬWarning: Try to keep at least 8 feet distance from all active users
➢ Splitter and combiner
The barriers such as wall will affect the signal transmission remarkably in indoor coverage area. We
can separate multiple sever antenna by using a splitter or combiner to run around some barriers
such as wall and cover the aimed area. For example, the sever antenna can’t be mounted in
adequate height as terrain limits, which will affect coverage greatly, we can also plant multiple sever
antenna to improve coverage area
7) Installing the Signal Booster
Select a location for the signal booster which is away from excessive heat, direct sunlight, moisture
and is not subject to high temperatures. Do not place the signal booster in an air-tight enclosure.
Recommended installation locations for in-building signal boosters are in a closet or on a shelf where
power is available. Attic installations may expose the booster to high heat.
Note: Do not install in areas subject to temperatures in excess of 150 °F.
Note: Maintain at least 6 inches of clearance from surrounding objects. Be careful when
plugging the connector in so as not to damage the center pins on the connectors. Run the
outside antenna cable to the signal booster and attach it to the connector labeled “BS” on the
signal booster. Run the inside antenna cable to the signal booster and attach it to the connector
labeled “MS” on the signal booster.
ꙬWarning: Ensure donor antenna and service antenna are all connected with signal booster before
you power on booster