User's Manual

FCC Warning

Specific Absorption Rate (SAR) information SAR tests are conducted

using standard operating positions accepted by the FCC with the phone

transmitting at its highest certified power level in all tested frequency

bands, although the SAR is determined at the highest certified power

level, the actual SAR level of the phone while operating can be well below

the maximum value, in general, the closer you are to a wireless base

station antenna, the lower the power output.

Before a new model phone is a available for sale to the public, it must be

tested and certified to the FCC that it does not exceed the exposure limit

established by the FCC, Tests for each phone are performed in positions

and locations (e.g. at the ear and worn on the body)as required by the

FCC.

For body worn operation, this mobile phone has been tested and meets

the FCC RF exposure guidelines when used with an accessory designated

for this product or when used with an accessory that contains no metal

and that positions the handset a minimum of 1.0cm from the body.

This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation. Any Changes

or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the