User's Manual

7
near the television, radio or other electrical appliances.
2 Getting Started
2.1 Overview and Introduction
2.1.1 Product Specification
Phone
Model
Dimension
Weight
Battery
Model
Nominal Voltage 3.7V
Limiting Voltage 4.2V
Rated Capacity
Standby Time
Talk Time
Model
Input
2.2 Keypad
“Press some key” hereof indicates that press the key and then relax it; “Press and hold some
key” hereof indicates that press and hold the key for two or more seconds.
2.3 Battery
The initial state of battery charge of about 50% the electricity. The first three complete charge
please run out of power after the full use of this battery easy to achieve the best use of state.
Install and Remove the Battery
You should follow these steps to remove the battery: Open the battery back; Remove the ①②
battery from back-end mobile phones.
You should follow these steps to install the battery: Insert the front① -end of the battery into the
phone; Put the rear cover back.②
Charge the Battery
 Plug in the charger.
 Insert the connector plug into the connector port on the bottom of your phone.
 Then the Battery Level icon displays in top right corner of the screen will flicker regularly. If
your phone is power off, a charge indicator will display in the screen and indicates that the battery is
charging. If the battery is too low the charge indicator will display in the screen for a moment.
 When the icon is full and does not flicker, it indicates that the battery is completely charged.