User's Manual

8
2 Getting Started
2.1 Overview and Introduction
2.1.1 Product Specification
Phone
Model i3220
Battery
Model BL-4C
Nominal Voltage 3.7V
Limiting Voltage 4.2V
2.2 Keypad
“Press some key” hereof indicates that press the key and then relax it; “Press
and hold some key” hereof indicates that press and hold the key for two or more
seconds.
2.3 Battery
The initial state of battery charge of about 50% the electricity. The first three
complete charge please run out of power after the full use of this battery easy to achieve
the best use of state.
Install and Remove the Battery
You should follow these steps to remove the battery: Open the battery back; ①②
Remove the battery from back-end mobile phones.
You should follow these steps to install the battery: Insert the front① -end of the
battery into the phone; Put the rear cover back.②
Charge the Battery
 Plug in the charger.
 Insert the connector plug into the connector port on the bottom of your phone.
 Then the Battery Level icon displays in top right corner of the screen will flicker
regularly. If your phone is power off, a charge indicator will display in the screen and
indicates that the battery is charging. If the battery is too low the charge indicator will
display in the screen for a moment.
 When the icon is full and does not flicker, it indicates that the battery is
completely charged. If your phone is power off, the system will display “charging
complete”. The charging process usually spend 3-4 hours. In the process of charging your
phone、battery and charger will become hot that it is a normal phenomenon.
Notice:
The phone must be charged with the approved charger in the ventilated places
where temperature is below 40°C and above 5°C.The use of any other disapproved