User's Manual

24
Poor signal Move to the areas of good signal.
Call Barring is activated. Inactivate Call Barring. The phone
can not make
calls.
Fixed Dial is activated. Inactivate Fixed Dial.
Incorrect
PIN Code
Enter an incorrect PIN
code 3 times in a row
Contact your network service
provider.
The battery or charger is
damaged.
Change for a new battery or charger.
The temperature of
charging environment is below
-10°C or above 55°C.
Change the charging environment.
The phone
can not be
charged.
Bad contact Check the connection of the
connector.
New entries
can not be added
to the phonebook.
The phonebook is full. Delete some entries of the
phonebook.
Some
functions can not
be set.
The network service
provider does not provide this
service or you do not apply for
this service.
Contact your network service
provider.
FCC Caution
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the