Technical Specs

to try to correct the i
and on, the user is encouraged
ticular installation. If this equipment
does cause har
rdance with the instructions, may cause
to operate the eq
s authority
undesir
eived, including interference that may cause
s when used with an accessory designated for this
limit establishe
that it does not exceed the exposure
although the SAR is determined at the high
FCC Warning
Specific Absorption Rate (SAR) information SAR tes
ts are conducted using standard operating positions
accepted by the FCC with the phone transmitting at
its highest certified power level in all tested frequenc
y bands,
est certified power level, the actual SAR level of the
phone while operating can be well below the maxim
um value, in general, the closer you are to a wireles
s base station antenna, the lower the power output.
Before a new model phone is a available for sale to
the public, it must be tested and certified to the FCC
d by the FCC,
Tests for each phone are performed i
n positions and locations (e.g. at the ear and worn o
n the body)as required by the FCC.
For body worn operation, this mobile phone has bee
n tested and meets the FCC RF exposure guideline
p
roduct or when used with an accessory that contain
s no metal and that positions the handset a minimum of 10mm from the bod
y.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference rec
ed operation.
Any Changes or modifications not exp
ressly approved by the party responsible for complia
nce could void the user’
uipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pu
rsuant to part 15 of the FCC Rules.
These limits are
designed to provide reasonable protection against h
armful interference in a residential installation.
This
equipment generates uses and can radiate radio fre
quency energy and, if not installed and used in acco
rference to radio communications. However, there is
no guarantee that interference will not occur in a par
mful interference to radio or television reception, wh
ich can be determined by turning the equipment o
ff
nterference by one or more of the following measur
es:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment an
d receiver.
--Connect the equipment into an outlet on a circuit di
fferent from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV tec
hnician for help.
harmful inte