Owner's Manual
Table Of Contents
- Quick Start Guide
- User Guide
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Introduction
- Features
- Setting Up
- installation
- Connecting to Your Wi-Fi Network
- Registering Online
- Setting Time and Day
- Setting the Fan
- Selecting System Mode
- Adjusting Program Schedules
- Overriding Schedules Temporarily
- Overriding Schedules Permanently
- unregistering the Thermostat
- Disconnecting Wi-Fi
- Software Updates
- Smart Response Technology
- Compressor Protection
- Auto Changeover
- Setting Functions and Options
- System Setup
- FAQs
- Troubleshooting
- Glossary
- Thermostat ID Card
- Quick Reference Card
- Wiring Labels
- Warranty
17 69-2715EF—07
Smart Response Technology
This feature allows the thermostat to “learn”
how long the heating/cooling system takes to
reach programmed temperature settings, so
the temperature is reached at the time you set.
For example: Set the Wake time to 6:00 am,
and the temperature to 70°. The heat will come
on before 6:00 am, so the temperature is 70°
by 6:00 am.
Note: System setting function 13 controls
Smart Response Technology. See “Smart
Response Technology” on page 19.
The message Recovery is
displayed when the system
is activated before a
scheduled time period.
M33881
Compressor protection
This feature forces the compressor to wait
a few minutes before restarting, to prevent
equipment damage.
The message Cool On (or Heat On
for a heat pump) will flash during
the wait time.
M33882
Auto changeover
This feature is used in climates where both air
conditioning and heating are used on the same day.
When the system is set to Auto, the thermostat
automatically selects heating or cooling depending on
the indoor temperature.
Heat and cool settings must be at least 3 degrees
apart. The thermostat will automatically adjust settings
to maintain this 3-degree separation.
Note: System setting function 12 controls Auto
changeover. See “Manual/Auto Changeover” on page
19.
MCR33893