Owner's Manual
Table Of Contents
- Quick Start Guide
- User Guide
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Introduction
- Features
- Setting Up
- installation
- Connecting to Your Wi-Fi Network
- Registering Online
- Setting Time and Day
- Setting the Fan
- Selecting System Mode
- Adjusting Program Schedules
- Overriding Schedules Temporarily
- Overriding Schedules Permanently
- unregistering the Thermostat
- Disconnecting Wi-Fi
- Software Updates
- Smart Response Technology
- Compressor Protection
- Auto Changeover
- Setting Functions and Options
- System Setup
- FAQs
- Troubleshooting
- Glossary
- Thermostat ID Card
- Quick Reference Card
- Wiring Labels
- Warranty
2.3 Make sure your thermostat is
connected
While the connection is in process, your
thermostat will flash WaitFORUPTOMINUTES
When the connection is complete, the
display will show Wi-Fi Setup Connection
Success. The Wi-Fi signal strength will
appear in the top-right corner.
After about 60 seconds, the home screen
will appear and Register at Total Connect
will flash until
3TEP (registration) is
complete.
Note: If the thermostat displays Connection
Failure or continues to display Wi-Fi Setup,
confirm you correctly entered your home
network password in step 2.2c. If correct,
refer to the FAQ at wifithermostat.com/support