VisionPRO Product Manual

VISIONPRO
®
8000 WITH REDLINK™
119 68-0312—02
Fig. 312. Inserting wires in thermostat terminal block.
Fig. 313. Inserting wires in EIM terminal block
IMPORTANT
Use 18–22 gauge thermostat wire.
Table 11. Wiring Diagrams by System Type.
System Type
Wiring Diagram
Reference
Standard Heat/Cool 314
Heat Pump with Auxiliary Heat 315
Geothermal radiant heat 316
Heat pump with oil forced air backup. 320
Geothermal radiant heat with geothermal
forced air and backup heat using separate
transformer for the radiant heat
321
Wood stove-fired hot water fan coil with
forced air furnace backup heat
322
Hot water radiant heat with backup heat
(single zone application)
323
Hot water radiant heat with backup forced
air heat. Zoned with forced air zone panel
and zone valves
324
Hot water radiant heat with backup forced
air heat. Zoned with forced air zone panel
and hot water panel.
325
Hot water fan coil with forced air furnace
backup heat.
326
Wood stove with heat pump and backup
electric strips. (For applications in which
the thermostat only needs to run the
blower fan when stove is hot).
Wiring IAQ Equipment or a stage of
Heating/Cooling to U1, U2 or U3 terminals
327–337
Wired Remote Sensors 342–346
Table 12. Zoning Diagrams by System Type.
System Type
Wiring Diagram
Reference
RedLINK VisionPRO thermostats with an
HZ432 zone panel and no IAQ control
347
RedLINK VisionPRO thermostat
controlling one zone with an HZ432 zone
panel and a TrueSTEAM humidifier
348
RedLINK VisionPRO thermostat with an
HZ432 zone panel and a ventilator
349
RedLINK VisionPRO thermostat with an
HZ432 zone panel and a TrueDRY
dehumidifier
350
S1
S1
W
Y
G
W2
Y2
A
S1
S1
O/B
Y
G
AUX
-E
Y2
L/A
K
RC
R
U1
U1
U2
U2
C
CONVENTIONAL
HEAT PUMP
R
C
Y
Y2
G
W
O/B
W2
AUX1
W3
AUX2
A
L/A